BP012 White 2000 LB ASPHALT PLANT L501

2000 LB ASPHALT PLANT L501 Cold Feed Bin:
• 11’ x 11’
• 2 separate compartments inside with divider
• 2 separate adjustment feeder gates – both 14” Wide
• Power supplied from cold elevator
• Top Sideboards added

Cold Elevator:
• Size – 25” x 22” x 16’5” T
• Receiving hopper – 28” x 32”
• Buckets – 14”L x 8”W x 5.5” D
• Single 2” Chain
• 5HP Drive Motor

Dryer:
• Frame – 5’ x 34’
• Dryer – 52” W x 20’ L x ¼” Thick
• 4 Beveled Trunnions – 3” Face – 4 ¼” Total width with outer ring
• 3” Tires; 3” supports on each side
• 2” Drive Chain
• 15HP/1750RPM Motor with Dodge TDT6 Reducer

Burner-Blower:
• Low Pressure Fuel Oil Burner
• 10HP/3480RPM Blower – TBA-24-10-0-1; SN#723700
• Refractory Cone with Fire Bricks with 3’4” Combustion Chamber
• Separate Fuel Pump
• Pilot on Propane
• Propane Tank: Certified Tank & MFG SN#87278

Hot Elevator:
• Box Dims – 21” x 43”
• Buckets – 14’L x 8”W x 5.5”D
• Single 3” Chain
• 10HP Motor with Dodge Reducer

Hot Storage Bin:
• Enclosed Storage Bin
• 7 ½ Ton Capacity
• Overflow Chute
• Air operated discharge gate

 
Pugmill Mixer:
• Tower structure – 4 legs – 13’L x 9’5”W
• Pugmill – 4’8” x 5’
• 30HP/1760RPM Motor with Dodge Reducer
• 2000lb capacity
• Twin shaft design
• Abrasion resistant liner
• Reversible alloy blade tips
• Mixer jacketed for hot oil
Asphalt Control Unit:
• Heated asphalt meter with totalizing register
• Asphalt spray bar in mixer with piping and valves
Batch Hopper:
• 20 Cubic Foot Capacity
• Single Beam Cardinal Scale SH-2 SN#26842 2000lb
• Air Operated Discharge Gate

Exhaust Fan/Duct:
• 41” Exhaust Fan
• 30HP/1760RPM Motor
• 20” Exhaust Stack
• 7’ Cyclone/Duct work with fines return system to hot elevator

Controls:
• Manual control station on pug mill tower

Compressor:
• 25cfm compressor with air receiver tank
• 5HP Baldor Motor

Notes:
• Was being used with Wet Scrubber
• Was rewired approximately 10 years ago
• Customer retaining AC tank/Pumps and Heater
• Has new blower and misc. parts
• New tips and shanks in pugmill
• 440V – 3 Phase System
• Was hauled in on 3 – 40 Semis originally (minus the wet scrubber)
• Has all books and blueprints
• Dryer/Flighting has been replaced previously
• Was being ran on a 50/50 blend of #2 & #4 oils
• Was primarily used to make Cold Mix @ approximately 33TPH